Docs.fortinet.com

Using SNMP to monitor health check FortiGate / FortiOS 7.4.1

WEBExample. This example shows a SD-WAN health check configuration and its collected statistics. To configure the SD-WAN health check: config system sdwan set status …

Actived: 8 days ago

URL: https://docs.fortinet.com/document/fortigate/7.4.1/administration-guide/971573

Configuring health checks FortiADC 7.4.0

WEBCopy Link. Configuring health checks. In server load balancing deployments, the system uses health checks to poll the members of the real server pool to test whether an …

Category:  Health Go Health

Check HA synchronization status FortiGate / FortiOS 7.0.0

WEB# get system ha status HA Health Status: OK Model: FortiGate-VM64 Mode: HA A-P Group: 0 Debug: 0 Cluster Uptime: 0 days 2:24:46 Cluster state change time: 2021-04 …

Category:  Health Go Health

Health check FortiGSLB 23.2.0

WEBHealth check. In Global Server Load Balance (GSLB) deployments, the system uses health checks to poll the virtual servers to test whether or not the virtual serve is available. In …

Category:  Health Go Health

Passive WAN health measurement FortiGate / FortiOS 7.0.0

WEBPassive WAN health measurement. SD-WAN passive WAN health measurement determines the health check measurements using session information that is captured …

Category:  Health Go Health

Support HTTPS performance SLA health checks 7.4.1

WEBconfig system sdwan set status enable config zone edit "virtual-wan-link" next end config members edit 1 set interface "port1" set gateway 172.16.200.254 set gateway6 …

Category:  Health Go Health

Check SD-WAN health FortiExtender 7.4.0 Fortinet Document …

WEBThe following commands are used to define a vwan_health_check and use it to perform health check for the VWAN member, member1. config hmon hchk edit vwchk1 set …

Category:  Health Go Health

server-policy health FortiWeb 7.4.1 Fortinet Document Library

WEBping. timeout <seconds_int>. Enter the number of seconds which must pass after the server health check to indicate a failed health check. The valid range is 1–10 . 3. retry-times …

Category:  Health Go Health

Check HA sync status FortiGate / FortiOS 6.2.16

WEBIn the CLI, run the command get sys ha status to see if the cluster is in sync. The sync status is reported under Configuration Status. In the following example, both …

Category:  Health Go Health

SD-WAN related diagnose commands

WEBThis topic lists the SD-WAN related diagnose commands and related output. To check SD-WAN health-check status: FGT # diagnose sys sdwan health-check Health Check

Category:  Health Go Health

Redirecting to /document/fortigate/7.4.1/administration-guide

WEBRedirecting to /document/fortigate/7.4.1/administration-guide.

Category:  Health Go Health

Monitoring performance SLA FortiGate / FortiOS 7.4.3 Fortinet

WEBThe live charts show the packet loss, latency, or jitter for the selected health check. Hover the cursor over a line in the chart to see the specific value for that interface at that …

Category:  Health Go Health

Redirecting to /document/fortigate/7.4.0/administration-guide

WEBRedirecting to /document/fortigate/7.4.0/administration-guide.

Category:  Health Go Health

FortiGate / FortiOS 7.4.0

WEB7.4.0. Download PDF. Copy Doc ID 5f000f73-5419-11ee-8e6d-fa163e15d75b:420966. Copy Link. CLI troubleshooting cheat sheet. This reference lists some important …

Category:  Health Go Health

Administration Guide FortiGate / FortiOS 7.2.0 Fortinet

WEBConfiguring the VPN overlay between the HQ FortiGate and AWS native VPN gateway. Configuring the VIP to access the remote servers. Configuring the SD-WAN to steer …

Category:  Health Go Health

Configuring network configuration FortiSASE 23.4.49 Fortinet

WEBHub health and priority: periodically obtain jitter, latency, and packet loss measurements for each hub via the health check IP address. FortiSASE selects the highest priority hub …

Category:  Health Go Health

Redirecting to …

WEBRedirecting to /index.php/document/fortigate/7.4.1/administration-guide.

Category:  Health Go Health

Redirecting to /document/fortigate/7.4.0/new-features

WEBRedirecting to /document/fortigate/7.4.0/new-features.

Category:  Health Go Health

Practical overlay examples FortiGate / FortiOS 7.2.0 Fortinet

WEBWe can configure an SD-WAN rule to select the best out of the overlays H1_ISP1 and H1_ISP2. If the health of the overlays changes during the call, the audio stream will …

Category:  Health Go Health